Using MBOX Studio
55
Using AVID FX
MBOX Reverb and Delay
MBOX Studio includes built-in EQ, delay and reverb using AVID FX.
• Use built-in 4-band EQ on input channels. Channel EQ can be applied to headphone and other MBOX Studio monitoring outputs
only, or applied to the channel send going to Pro Tools.
• Use AVID FX Delay and Reverb to have effects in headphones or other mixes for low latency monitoring.
AVID FX send faders are available on all input channels to set the level being sent to effects (all channels share the same delay and re-
verb settings).
Using AVID FX for Headphone Mixes
To apply AVID FX delay and reverb to a headphone mix:
1 In MBOX Control, click to select Headphone 1 or Headphone 2 in the Hardware Output section.
2 Adjust Hardware Input and Software Input levels and pan.
3 Click to select the first desired input channel. That channel is shown in Channel Focus.
4 In Channel Focus, raise the Avid FX Send fader until you see levels on its meter. The Channel Focus AVID FX Send fader controls
the FX send level for the currently focused channel.
5 Optional: Enable PRE to make the AVID FX send be tapped at the “top of channel” (meaning without any Channel Focus EQ).
6 Click AVID FX to open the AVID FX tab.
7 In the Hardware and Software Input sections all fader caps light purple; adjust a purple input fader to set its AVID FX Send level.
8 In the Hardware Output section the knobs at the top of each channel strip light purple; adjust a purple output channel encoder to set
the AVID FX Return level to that individual output.
9 Make sure the Avid FX Return Level is not muted, then raise the fader. This fader controls the level of AVID FX being returned in
all outputs.
Adjusting the AVID FX Send level for a channel
AVID FX Return Level fader
To Next Page
Loading...
Need help?
General
