Using MBOX Studio
58
5 Start Pro Tools playback.
6 In MBOX Control, select the Line/FX2 / Out to Amp hardware output, then slowly raise the fader for Internal 8 (in the Software In-
put
section) to adjust the level going to the amp.
7 While the track and session play, dial in the amp sound (adjust amp gain, volume, and tone controls as desired).
8 Set MBOX Studio input gain so input meters light green most of the time, and only light amber for louder signals.
9 In Pro Tools, record enable the destination (record) track for the re-amplified signal you created in step 4, above. Adjust device levels
as needed to have the Pro Tools track meter (on the recording track) only light amber when the loudest parts are playing.
10 When ready:
• Locate Pro Tools to the beginning of the material you want to re-amplify.
• Click Record in the Transport window to arm Pro Tools for recording. The Record button flashes red.
• Make sure the destination track is record enabled (its record button also flashes red) and then click Play or press the Spacebar.
11 Click Stop in the Transport window or press the Spacebar when you are finished recording.
Selecting Line/FX 2 output and adjusting Internal 8
Recording a re-amplified track
To Next Page
Loading...
Need help?
General
