MENU FUNCTION
-32-
6.4.5 Remote
In this menu list, you can set up remote devices to work properly.
Move the cursor to “REMOTE”, and press ”ENTER”. You will see a similar screen as the following:
ADVANCE
REMOTE
CAMERA
TITLE DEVICE ID PROTOCOL RATE
DETECTION 01 CAMERA 000 NORMAL 02400
DISPLAY 02 PTZ 255 P-D 02400
ALERT 03 CAMERA 000 NORMAL 02400
REMOTE
04 CAMERA 000 NORMAL 02400
SYSTEM 05 CAMERA 000 NORMAL 02400
NETWORK 06 CAMERA 000 NORMAL 02400
BACKUP 07 CAMERA 000 NORMAL 02400
HDD INFO 08 CAMERA 000 NORMAL 02400
EVENT LOG PREV NEXT
The submenu items are described below:
1) TITLE
Show the camera title of each channel set in “CAMERA”.
2) DEVICE
Select the device type (CAMERA / PTZ) according to the connected camera for each channel.
3) ID
Set the ID number (0 ~ 255) for a PTZ camera.
After connecting to a PTZ camera correctly, the default ID of the PTZ camera will be shown on the screen.
4) PROTOCOL
Select NORMAL (our protocol) or P-D (PELCO-D) protocol.
5) RATE
Set the baud rate of each channel (2400 / 4800 / 9600 / 19200 / 57600). For the connected cameras, such as PTZ and
speed dome cameras, etc., please make sure their baud rate setting is the same as the setting here.
6) PREV/NEXT
(Only for 16CH model)
Select “PREV” to go to the previous page, or “NEXT” to go to the next page.
Note: For detailed PTZ camera connection & setup, please refer to the section “3.2.2 PTZ” at page 8, and
“6.6.5 PTZ Camera Setup and Control” at page 43.
To Next Page
Loading...
Need help?
General
