QUICK OPERATION
17
5. QUICK OPERATION
5.1 Power Switch
Note: This function is available only for “SUPERVISOR”. To know more details, please refer to “4.4 User
Level Creation” at page 12.
To power off or reboot the NVR, you may go to , and select (power off) or (reboot).
5.2 Channel Selection
To display a specific channel in full screen and restore to the 6-cut view, you may:
Directly click the channel you want on the screen, and click it twice to restore to the 6-cut view (refer to “4.2
Channel Selection” at page 10), or
Go to , and select the channel you want to display in full screen from 1 ~ 6, and select to restore
to the 6-cut view.
5.3 Digital Zoom
Switch to the channel you want to zoom in, and click to enter the zoom-in mode. In this mode, click and
drag the red frame on the bottom left of the screen to move to the place you want to see.
To Next Page
Loading...
