24
Troubleshooting
If you suspect something is wrong, immediately switch power off. Immediately stop using it and
call the store where you purchased it. Never try to repair the unit yourself because it is dangerous
to do so.
General
- No power or no sound
Car engine switched off.
Turn on the car ignition.
Cable is not correctly connected. Check connection.
Fuse is burnt. Replace fuse.
Check volume or mute on/off.
If the above solutions cannot help,
press the
RESET
hole.
Disc
- Disc is inserted but no sound.
Disc is upside down.
Place disc right way up, with the label side up.
Disc is dirty or damaged
Clean disc or change disc.
- Disc sound skips, tone quality is low.
Disc is dirty or damaged.
Clean CD or change another CD.
- Sound skips due to vibration.
Mounting angle is over 30
o
.
Adjust mounting angle to less than 30
o
.
Unstable mounting.
Mount the unit securely with the mounting parts.
Radio
- Interference noise during broadcast
Station is too far, or signals are too weak.
Select other stations of higher signal level.
- Preset station lost
Battery cable is not correctly connected.
Connect the battery cable to the live terminal.
Error Display Messages
- Display shows ERROR.
Disc is dirty, damaged or upside down.
Press to eject the disc.
- When video le initializing time is too long.
File read error or file type not supported.
Press
SRC
to exit. Then press
SRC
to play disc again.
To Next Page
Loading...
