22
Important:
Remove these two screws before installation. Otherwise, the DVD player will not work.
1. Inset mounting collar into the dashboard, and bend the mounting tabs out with a
screwdriver.
Make sure that lock lever
is flush with the mounting collar (not projecting outward).
2. Secure the rear of the unit.
After fixing mounting bolt and power connector, fix the rear of the unit to the car body by
rubber cushion.
3. Insert trim plate.
Lock lever
Installation Guide
Installation Procedures
Carefully complete the electrical connections. Check connections before operation.
Reset
Press to flip down the panel. Then press the Reset hole with a pointed object to reset the unit
to the original factor settings.
Installation Opening
This unit can be installed in any dashboard with a suitable 183mm(w) x 52mm (h) opening as
shown above. The dashboard should be 4.75 mm - 5.56 mm thick in order to be able to support
the unit.
To Next Page
Loading...
