EasyManuals Logo

Axis Q1755 User Manual

Axis Q1755
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
48
AXIS Q1755/-E - About
About
Here you can find basic information about your network camera. You can also view third party software licenses.
Resetting to the Factory Default Settings
To reset the camera to the original factory default settings, go to the System Options > Maintenance web page (as described
in Maintenance, on page 46) or use the Control button on the side of the camera (see page 5) as described below:
Using the Control Button
This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power.
3. Keep the Control button pressed until the Status indicator displays amber (this may take up to 15 seconds).
4. Release the Control button. When the Status indicator displays green (which can take up to 1 minute) the process is
complete and the camera has been reset. All parameters are set to factory default value.
Note:
For other methods of setting the IP address, please refer to the product’s Installation Guide that accompanies the
product, or download a copy from www.axis.com

Other manuals for Axis Q1755

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Axis Q1755 and is the answer not in the manual?

Axis Q1755 Specifications

General IconGeneral
Maximum resolution1920 x 1080 pixels
Camera shutter speed1/10000 - 1/2 s
Minimum illumination2 lx
Sensor typeCMOS
Optical sensor size1/3 \
Sample rate16 kHz
Supported network protocolsIPv4/v6, HTTP, HTTPS, QoS Layer 3 DiffServ, FTP, SMTP, Bonjour, UPnP, SNMPv1/v2c/v3(MIB-II), DNS, DynDNS, NTP, RTSP, RTP, TCP, UDP, IGMP, RTCP, ICMP, DHCP, ARP, SOCKS, Pelco-D
Power source typePoE
Power over Ethernet (PoE)Yes
Power consumption (typical)17.4 W
Ethernet LAN (RJ-45) ports1
Dimensions (WxDxH)186 x 85 x 211.4 mm
Power requirements20 - 24 V AC
CertificationEN 55022 Class B, EN 61000-3-2, EN 61000-3-3, EN 55024, EN 61000-6-1, EN 61000-6-2, EN 60950-1, FCC Part 15, Subpart B, Class B, VCCI, Class B ITE, C-tick AS/NZS CISPR 22, ICES-003, Class B
Processor modelARTPEC-3
Flash memory256 MB
Internal memory128 MB
Operating temperature (T-T)0 - 45 °C
Operating relative humidity (H-H)20 - 80 %
Weight and Dimensions IconWeight and Dimensions
Weight985 g

Related product manuals