Axis S2216 Mk II - Manage Certificates

AXIS Camera Station S2216 Mk II Appliance
Manage the built - in switch
2. Drag and drop the backup le or click Browse and navigate to the backup le.
3. Click Upload .
It can take a few minutes to restore the switch from the backup le. Once the settings are restored, the switch will automatically
reboot, and you will need to log in again.
Manage certicates
1. In the menu bar , go to Maintenance > Manage certicates .
2. Click and navigate to your private key le.
3. Click and navigate to your certicate le.
4. Click and navigate to your CA bundle le.
5. Click Save .
6. Reboot the switch.
Change password
Y ou can change the switch's default password to a password you choose yourself.
Important
Make sure to select a password you can remember . If you forget the password, see to restore the factory default password.
1. In the menu bar , go to Maintenance > Change password .
2. Enter the current password and your new password as required.
3. Click Save .
Congure web settings
1. In the menu bar , go to Maintenance > W eb settings .
2. Enter the port number .
Note
• If you decide to change the port number , make sure to write down the new port number . If you forget the new port
number , see to restore the factory default port number .
• W e recommend that you keep HTTPS enabled.
Reset to factory default settings
Hold down the reset button for ve seconds to reset the switch to its factory default settings.
Y ou can also reset the switch through the web interface:
1. In the menu bar , go to Maintenance > Reset to factory default settings .
2. Click Reset and Y es .
After the reset is done, the switch will reboot automatically .
28