Axis S2216 Mk II - Configure Your Device; Initial Axis Recorder Setup; Log in to the Server

AXIS Camera Station S2216 Mk II Appliance
Configur e your device
Configur e your device
Initial Axis recorder setup
After you have congured Windows®, AXIS Recorder T oolbox is opened automatically and you are guided through the rst - time
conguration setup assistant. In this setup assistant, you can congure several basic and necessary settings before you manage
your device in AXIS Recorder T oolbox.
Note
The settings are for the server . T o change the switch’s settings, go to the switch’s management page. See .
1. Select Light or Dark theme and click Next (if it’s available for your product).
2. Change the computer name if you want and click Next .
3. Under Date and time , congure the following settings and click Next .
- Select a time zone.
- T o set up an NTP server , select NTP server and enter the NTP server address.
- T o set manually , select Manual and select a date and time.
4. Under Network settings , congure the following settings and click Next .
- Use automatic IP settings (DHCP) and Use automatic DNS settings are turned on by default.
- If your device is connected to a network with a DHCP server , the assigned IP address, subnet mask, gateway , and
preferred DNS are automatically displayed.
- If your device is not connected to a network or there is no DHCP server available, enter the IP address, subnet
mask, gateway , and preferred DNS manually depending on the network requirements.
5. Click Finish . If you have changed the computer name, AXIS Recorder T oolbox will prompt you to restart the device.
Log in to the server
Using the AXIS Camera Station Pro client, you can connect to multiple servers or a single server installed on the local computer or
somewhere else on the network. Y ou can connect to AXIS Camera Station Pro servers in different ways:
Last used servers - Connect to the servers used in the previous session.
This computer - Connect to the server installed on the same computer as the client.
Remote server - See .
AXIS Secure Remote Access - See .
Note
When trying to connect to a server for the rst time, the client checks the server certicate ID. T o ensure that you’re
connecting to the correct server , manually verify the certicate ID with the one displayed in AXIS Camera Station Pro
Service Control.
Server list
T o connect to servers from a server list, select a one from the
Server list drop - down menu. Click to create or edit the
server lists.
Import server list
T o import a server list le exported from AXIS Camera Station,
click Import server list and browse to an .msl le.
7