User Manual
ports (or port section). Every group of ports must be set apart with a comma (,).
For example, 2000-2038, 2050-2051, 2085, 3010-3030.
Incoming Protocol The protocol used for Incoming Ports Range, either TCP or UDP,
or ALL (all protocols supported by the router).
Status The status of this entry either Enabled or Disabled.
To add a new rule:
1. Click Add New.
2. Enter a port number used by the application when it generates an outgoing
request.
3. Select the protocol used for Trigger Port:
TCP
UDP
All
4. Enter the range of port numbers used by the remote system when it responds to
the PC's request.
5. Select a protocol used for Incoming Ports Range:
TCP
UDP
All
6. Select the Status:
7. Click Save.
Page 63 of 102
To Next Page
Loading...
Need help?
General
