User Manual
4. I want to build a WEB Server on the LAN, what should I do?
Because the WEB Server port 80 will interfere with the WEB management port 80
on the router, you must change the WEB management port number to avoid
interference.
To change the WEB management port number: Login to the router, click the
Security menu on the left of your browser, and click Remote Management
submenu. On the Remote Management page, type a port number except 80, such
as 88, into the Web Management Port field. Click Save and reboot the router.
Note: If the above configuration takes effect, to configure to the router by typing
http://192.168.1.1:88 (the router’s LAN IP address: Web Management Port) in the
address field of the web browser.
3) Login to the router, click the Forwarding menu on the left of your browser, and
click the Virtual Servers submenu. On the Virtual Server page, click Add New, then
on the Add or Modify a Virtual Server page, enter 80 into the blank behind the
Service Port, and your IP address behind the IP Address, assuming 192.168.1.188
for an example, remember to Enable and Save.
5. The wireless clients cannot connect to the router.
Make sure the Wireless Router Radio is enabled.
Verify the SSID.
Verify the wireless security key.
If the wireless connection is ready, but you cannot access the router, check the IP
Address of your wireless stations.
Page 96 of 102
To Next Page
Loading...
Need help?
General
