Baelz Automatic 373-E07 - Personnel Qualifications; Before Starting Work; Working Environment

BA_373-E07_04_DEF_MJ_1821
5 | 36W. Baelz & Sohn GmbH & Co. · Koep󰀨strasse 5 · 74076 Heilbronn · Germany · www.baelz.de Seite | Page
Motorized Linear Actuator baelz 373-E07
1.3 Personnel
Onlyqualiedpersonnelmayworkonthislinearactuatororinitsvicinity.Qualiedpersons
are deemed to be persons who are familiar with the installation, assembly, commissioning and
operationormaintenanceoftheactuatorsandhavetheappropriatequalicationsfortheirjob.
Necessaryorprescribedqualicationsinclude,butarenotlimitedto:
● Training / instruction and the authorization to switch electric circuits and devices /
systemsonando󰀨inaccordancewithEN60204(DINVDE0100/0113)andthe
technical safety standards
● Training or instruction in the care and use of appropriate safety and work protection
equipmentinaccordancewithsafetytechnologystandards.
● First aid training.
Work in a safe manner and avoid any operation that would endanger the safety of persons or
damage the linear actuator or other property in any way.
1.4 Before starting work
Beforecarryingoutanywork,checkwhetherthetypesspeciedherecorrespondtothe
information on the name plate of the actuator:
baelz 373-E07
1.5 During operation
Safe operation is only possible if transport, storage, assembly, operation and maintenance is
carried out in a safe, proper and professional manner.
1.5.1 Transport, installation and assembly
Observe the general installation and safety regulations for heating, ventilation, air conditioning
andpipingsystems.Usetoolsonlyfortheirintendedpurpose.Weartherequiredpersonaland
otherprotectiveequipment.
1.5.2 Maintenance and repair
Prior to maintenance or repair, make sure that the linear actuator is disconnected from power
byqualiedpersonnelinaccordancewithDINVDEstandards.TheE07isalowmaintenance
linear actuator. Depending upon usage, it may be necessary to occasionally grease the
actuator spindle with „Gleitmo 805“.
1.6 Working environment
Notetheinformationonworkingenvironmentinthetechnicalspecications.