64 Instrument and control system
D50
2
Operation system and specification
Travel time / average speed
The travel time is the accumulated running time
from the time when the travel time is cleared to
the current time, and the start/stop button starts
timing when it is in the "RUN" mode.
The maximum value displayed is 99:59.
The average vehicle speed is the speed of the
vehicle divided by the driving time during the
driving time.
Clear mode:
1. On the display interface, press the long button
to pop up the reset popup window. Select _
Short press _Select to confirm in the reset
popup window;
2. The start/stop button is located at “OFF” for 2
consecutive hours;
3. The driving time reaches the maximum value
of 99:59;
4. Disconnect the battery.
Endurance mileage / instantaneous fuel
consumption
The cruising range is based on the driver's
driving habits in the previous paragraph. Based
on the current remaining fuel quantity, the
mileage value that can be traveled is estimated.
When the driving habit changes, the cruising
range value will also change. When the
estimated mileage is less than 30km, the
cruising range shows “Low”.
Instantaneous fuel consumption shows the
current fuel consumption, the display unit is
L/100km, and the instantaneous fuel
consumption is displayed at idle speed.
Set instrument
When the start/stop button is in “RUN” mode,
press the key MENU to the meter setting
interface. After entering the meter setting
interface, press the up/down button to “fetal
pressure system”, “alarm volume”, “unit
setting”, “fatigue driving”, “maintenance
information”, “fault view”, “restore factory” ”
Browse, short press the button to select, short
press MENU to return to the previous interface.
Tire pressure system
After entering the tire pressure system interface,
you can view
To Next Page
Loading...
Need help?
General
