PanaFlow™ XMT1000 User’s Manual 27
Chapter 3. Programming
3.3.1.2 Selecting a Composite Measurement to Display
To select a composite measurement to display on the Measurement View, do the following steps and refer Figure 24.
1. Press [] until the Measurement name on the meter’s Measurement View display is highlighted, and press
[ENTER].
2. In the Display Measurement select [Composite], then press [ENTER].
3. Then, select the measurement you would like to see on the Measurement View and press [ENTER].
Figure 24: Selecting a Composite Measurement to Display
To Next Page
Loading...