Chapter 3. Programming
28 PanaFlow™ XMT1000 User’s Manual
3.3.1.3 Selecting a Channel Measurement to Display
To select a Channel measurement to display on the Measurement View, do the following steps and refer Figure 25.
1. Press [] until the Measurement name on the meter’s Measurement View display is highlighted, then press
[ENTER].
2. In the Display Measurement select [Channel x], then press [ENTER].
3. Then, select the measurement you would like to see on the Measurement View and press [ENTER].
Figure 25: Selecting a Channel Measurement to Display
To Next Page
Loading...