PanaFlow™ XMT1000 User’s Manual 29
Chapter 3. Programming
3.3.1.4 Totalizer Display
The Totalizer display on the Measurement View shows the totalized measurements and provides the ability to start,
stop and reset totals. Refer to Figure 23 to set Display format to Totalizer. Do the following steps to select the
appropriate Totalizer measurements to view on the Measurement View. Refer to Figure 26.
1. Press [] button on the keypad until the Measurement name on the meter’s Measurement View display is
highlighted, and press [ENTER].
2. In the Display/Totalizer, select [Composite] or [Channel x], then press [ENTER].
3. Then, select the totalizer measurement you would like to see on the Measurement View and press [ENTER].
4. Press [] button on the keypad until the [or ] is highlighted to stop or start the totalizing respectively.
5. Press [] button on the keypad until the [] is highlighted to reset/clear the totalized measurements.
Figure 26: Selecting Totalizer Measurements for Display
To Next Page
Loading...