Index
MN1901
A
Abbreviations. See Units and Abbreviations
Absolute encoder
cable, 3-28, 3-30, A-4
EnDat option, 3-27
Hiperface option, 3-29
specification, 8-11
Accessories, A -1
EMC filters, A-6
feedback cables, A-3, A-4
motor power cables, A-2
regeneration resistors, A-9
Analog I/O, 4-1
analog input - X3 (demmand), 4-2
analog input - X4, 4-4
analog output - X4, 4-6
B
Basic Installation, 3-1
C
Catalog number , identifying, 2-2
CE Guidelines, D- 1
declaration of conformity, D-2
Commissioning Wizard, 5-7
completing, 5-7
using, 5-7
Configuration, 5-9
performing a test move, 5-8
Connections
See also Input / Output
feedback, 3-21
motor , 3-15
motor brake, 3-19
power , 3-8
single phase, 3-9
three phase, 3-10
thermal switch, 3-18
Connector , locations, 3-7
Control system, B-1
operation
position controller , B-5
speed controller, B-6
torque controller and feedback, B-7
positioning with speed controller , B-1
positioning without speed controller, B-2
speed amplifier, B-3
torque amplifier , B-4
D
DB On LED, 7 -5
Digital I/O, 4-7
CREF, 4-9
digital inputs - X3, 4-8
digital outputs - X3, 4-12, 4-13
fast inputs, 4-9
pulse & direction, 4-9
special functions, 4-9
Dimensions, 3-6
DIP switches, 3-33
1-4: Node select, 3-33
5: Hold, 3-34
6: RS485 terminator, 3-34
7: Offset tuning, 3-34, 5-3
8: Enable, 3-34
9 & 10: RS232/RS485 select, 3-35
factory settings, 3-35
preventing a program running, 3-36
Drive enable
command, 3-32
DIP switch 8, 3-32
X3 CREF, 3-31
Dual encoder feedback, following, 4-17
Dynamic brake. See Regeneration resistor
E
Encoder
absolute. See Absolute encoder
Index
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
