142
Technical data • Individual components
Panel PC 700 with 945GME N270 CPU board User's Manual V 1.16
Cutout installation
The Panel PC 700 with preassembled mounting blocks is installed e.g. in a housing cutout. A
cutout that corresponds to the following drawing must be made.
For further information regarding mounting and installation position, see chapter 3
"Commissioning", on page 219.
Figure 68: Cutout installation - 5PC720.1706-00
0
Cut-out dimensions 460 ±0.5 mm x 373±0.5 mm suitable for
5PC720.1706-00
Cut-out
Outer contours (Panel PC 700)
8.5
477
468.5
0
390
8.5
381.5
To Next Page