Banner D10 Series - Push Button Lockout

Method Action Result
Remote Input
a. Double-pulse the remote line to toggle between
selections.
b. Single-pulse the remote line to save selection
and advance to "Factory Default."
T T
T
T
3. Return the sensor to the factory default settings, if desired.
Method Action Result
Push Button
a. Click Dynamic (+) to toggle between selections.
b. Click Static (-) to save selection and advance to
"Display Orientation."
Returns to factory default factory
settings
Factory Default Settings Not Selected:
Display shows "Fd n"
Factory Default Settings Selected:
Display shows "Fd Y"
Remote Input
a. Double-pulse the remote line to toggle between
selections.
b. Single-pulse the remote line to save selection
and advance to "Display Orientation."
T T
T
T
4. Change the display orientation, if desired.
Method
Action Result
Push Button
a. Click Dynamic (+) to toggle between selections.
b. Click Static (-) to return to RUN mode.
Inverts display to read "upside-
down"
Normal
For example: 1234
Inverted
For example:
NOTE: Icons do
not invert.
Remote Input
a. Double-pulse the remote line to toggle between
selections.
b. Single-pulse the remote line to return to RUN
mode.
T T
T
T
Push Button Lockout
• Prevents unwanted adjustments or tampering of the push buttons
• Push buttons can be enabled or disabled only from the remote line and only during normal RUN mode
Method
Action Result
Push Button
22
Not available with push-button programming. Push buttons Disabled
• Display flashes "loc"
• Padlock icon appears
• Sensor remains in RUN mode
Push Buttons Enabled
• Display flashes "uloc"
• Padlock icon disappears
• Sensor remains in RUN mode
Remote Input
23
From RUN mode, quad-pulse the remote line to
toggle between selections.
T T
T T T
T T
22
0.04 seconds ≤ "Click" ≤ 0.8 seconds
23
0.04 seconds ≤ T ≤ 0.8 seconds
D10 Expert
™
– Dual Discrete Outputs
P/N 64154 Rev. G www.bannerengineering.com - Tel: +1-763-544-3164 13