Datasheet
Advanced sensor for use with plastic fiber optics
• Easy-to-set automatic Expert-style TEACH options
1
including static, dynamic, and
single-point programming plus manual adjustment for fine-tuning
• 16-bit microcontroller and 12-bit Analog-to-Digital converter for high-
performance, low-contrast sensing
• Easy-to-read 4-digit display for TEACH and signal strength readout, plus
indicators for a continuous readout of operating status (user configurable)
• Two discrete outputs, PNP or NPN
• Four-mode power and speed selection with automatic cross-talk avoidance
circuitry
• Selectable OFF-delay options
• Gate input wire can be used to selectively inhibit sensor outputs from switching
• Models available with visible red (680 nm) or visible green (525 nm) sensing
beam
• Models available with 2 m or 9 m (6.5 ft or 30 ft) cable or integral Pico-style
quick-disconnect
• Sleek, ultra-slim 10 mm housing, mounts to a standard 35 mm DIN rail
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to
serious injury or death. This device does not include the self-checking redundant circuitry necessary
to allow its use in personnel safety applications. A sensor failure or malfunction can cause either an
energized or de-energized sensor output condition.
Models
Red Beam Models
Green Beam Models Cables
2
Discrete Outputs
D10DNFP D10DNFPG 2 m (6.5 ft) Cable
NPN
D10DNFPQ D10DNFPGQ 6-pin Pico-style QD
D10DPFP D10DPFPG 2 m (6.5 ft) Cable
PNP
D10DPFPQ D10DPFPGQ 6-pin Pico-style QD
1
U.S. Patent #5,808,296
2
To order the 9 m (30 ft) PVC cable model, add the suffix "W/30" to the cabled model number. For example, D10DNFP W/30. Models with a quick disconnect
require a mating cordset.
D10 Expert
™
– Dual Discrete Outputs
Original Document
64154 Rev. G
8 December 2016
To Next Page
Loading...
