Banner DF-G3 Long Range Expert User Manual

1. Congure the
rst sensor as the Master (inPt SEL = MAST).
2. In the Master sensor set-up, enter the total number of Slave sensors you will be using (tOtL SLAV = 1 - 6).
3. For each Slave sensor used, congure the input as a Slave (inPt SEL = SLVE).
4.
Give each Slave its own idenfying address (SLAV Addr = 1 - 6).
5.
Connect the Input wires of the Master and all of the Slaves together.
Note: Note: Giving two Slave sensors the same address will cause them to re their
emiers at the same me in the ring
sequence.
3.5 Adjust Mode
Sliding the RUN/PRG/ADJ mode switch to the ADJ posion allows the user to perform Expert TEACH/SET methods and Manual
Adjustment of the threshold(s).
Note: For the Dual Output models, when teaching CH2, the gain seng will be the same as the gain seng made during the CH1
teach. Reteaching CH1 may invalidate the previous CH2 teach.
3.5.1 Two-Point TEACH
• Establishes a single switching threshold
• Threshold can be adjusted by using the "+" and "-" rocker buon (Manual Adjust)
Two-Point TEACH is used when two condions can be presented
stacally to the sensor. The sensor locates a single sensing threshold
(the switch point) midway between the two taught condions, with the Output ON condion on one side, and the Output OFF condion
on the other.
Sensor positions
threshold midway
between taught conditions
Darkest
(no signal)
Most Light
(saturated
signal)
Output OFF Output ON
Darkest Taught
Condition
Lightest Taught
Condition
Position
adjusted by
Manual
Adjust
Figure 6. Two-Point TEACH (Light Operate shown)
The Output ON and OFF condions can be reversed by using the LO/DO (Light Operate/ Dark Operate) switch or through the program
interface for the dual output model.
Two-Point TEACH and Manual Adjust
Moves switching threshold value up or down to make adjustments
•
Slide Mode switch to ADJ to enter Adjust mode
• Press "+" to increase; press "-" to decrease
◦ GREEN display shows the switching threshold value
◦ 2 seconds aer adjustment, the GREEN display will ash 3 mes to conrm
• Slide Mode switch to RUN to complete operaon
Remember: Manual adjustments are disabled when Auto Thresholds are ON
Follow these steps to perform a Two-Point TEACH:
Note: TEACH Selecon must be programmed to 2Pt tcH.
1. Enter Adjust mode.
DF-G3 Long Range Expert
™
Dual Display Fiber Amplier
16 www.bannerengineering.com - Tel: 763.544.3164

Banner DF-G3 Long Range Expert Specifications

General

Brand	Banner
Model	DF-G3 Long Range Expert
Category	Amplifier
Language	English