Banner DF-G3 Long Range Expert - Window SET

4. Exit Dynamic TEACH.
Method Acon Result
SET Buon Click the SET rocker buon TEACH Accepted
Displays alternate "PASS" with % Minimum
Dierence
10
, Sensor returns to Adjust
mode
TEACH Not Accepted
Displays alternate "FAIL" with % Minimum
Dierence
10
, Sensor returns to Adjust
mode
Remote Input Single-pulse remote input
T
5. Return to RUN Mode.
Method Acon Result
SET Buon Move Mode switch to RUN Display: Red - Signal Level; Green -
Threshold
Remote Input No acon required; sensor returns to RUN
mode automacally
3.5.3 Window SET
•
Sets window thresholds that extend a programmable % oset above and below the presented condion
• All other condions (lighter or darker) cause the output to change state
•
Sensing window center can be adjusted using "+" and "-" rocker buon (Manual Adjust)
•
Recommended for
applicaons where a product may not always appear in the same place, or when other signals may appear
• See Program Mode for programming the Oset Percent seng
A single sensing condion is presented, and the sensor posions window thresholds a programmable % oset above and below the
presented condion. In LO mode, Window SET designates a sensing window with the Output ON condion inside the window, and the
Output OFF condions outside the window.
Sensor positions
window thresholds
a programmable %
offset from the
presented condition
Darkest
(no signal)
Most Light
(saturated
signal)
Condition
Presented
Sensing window
center adjusted by
Manual Adjust
Output OFF Output OFFOutput ON
Figure 8. Window SET (Light Operate shown)
The Output ON and OFF condions can be reversed by using the LO/DO (Light Operate/ Dark Operate) switch or through the program
interface for the dual output model.
Window SET and Manual Adjust
Moves sensing window center value up or down to make adjustments
• Slide Mode switch to ADJ to enter Adjust mode
• Press "+" to increase; press "-" to decrease
◦ GREEN display shows the sensing window center value
◦ 2 seconds aer adjustment, the GREEN display will ash 3 mes to conrm
• Slide Mode switch to RUN to complete operaon
10
See Troubleshoong on page 25 for more explanaon of the % Minimum Dierence displayed aer the Dynamic TEACH method.
DF-G3 Long Range Expert
™
Dual Display Fiber Amplier
www.bannerengineering.com - Tel: 763.544.3164 19