Banner DF-G3 Long Range Expert - Page 20

Remember: Manual adjustments are disabled when Auto Thresholds are ON
Follow these steps to perform a Window SET:
Note: TEACH Selecon must be programmed to wind SEt.
1. Enter Adjust Mode
Method Acon Result
SET Buon
11
Set Mode switch to ADJ Display: Red - Signal Level; Green -
Threshold
Remote Input
12
No acon required; sensor is ready for
Window SET method
2. SET Sensing Condion
Method Acon Result
SET Buon • Present sensing condion
• Click the SET rocker buon
Threshold Condion Accepted Displays
read "wInd SEt" then alternate "PASS"
with % Oset
13
; Sensor returns to Adjust
mode
Threshold Condion Not Accepted
Displays read "wInd SEt" then alternate
"FAIL" with minimum % Oset
13
for
sensing condion; Sensor returns to Adjust
mode
Remote Input • Present sensing condion
• Single-pulse the remote input
T
3. Return to RUN Mode
Method Acon Result
SET Buon Move Mode switch to Run Display: Red - Signal Level; Green - Window
Center (see Figure 9 on page 20 for
instrucons on how to display upper and
lower thresholds)
Remote Input No acon required; sensor returns to Run
mode automacally
Window SET (during RUN mode)
Upon sensor power-up, Window Center is displayed
Upper
Threshold
Displayed
Window
Center
Displayed
Lower
Threshold
Displayed
Figure 9. Upper and Lower Thresholds
11
SET Buon: 0.04 seconds ≤ "Click" ≤ 0.8 seconds
12
Remote Input: 0.04 seconds ≤ T ≤ 0.8 seconds
13
See Troubleshoong on page 25 for more explanaon of the % Oset displayed aer the Window SET method
DF-G3 Long Range Expert
™
Dual Display Fiber Amplier
20 www.bannerengineering.com - Tel: 763.544.3164