Banner DF-G3 Long Range Expert - Light SET

3.5.4 Light SET
•
Sets a threshold a programmable % oset below the presented condion
• Changes output state on any condion darker than the threshold condion
• Threshold can be adjusted using "+" and "-" rocker buon (Manual Adjust)
•
Recommended for
applicaons where only one condion is known, for example a stable light background with varying darker
targets
• See Program Mode for programming the Oset Percent seng
A single sensing condion is presented, and the sensor posions a threshold a programmable % oset below the presented condion.
When a condion darker than the threshold is sensed, the output either turns ON or OFF, depending on the LO/DO seng.
Threshold position
adjusted by
Manual Adjust
Sensor positions
threshold a programmable
% offset below the
presented condition
Darkest
(no
signal)
Most Light
(saturated
signal)
Output OFF Output ON
Condition
Presented
Figure 10. Light SET (Light Operate shown)
Light SET and Manual Adjust
Moves switching threshold value up or down to make adjustments
•
Slide Mode switch to ADJ to enter Adjust mode
• Press "+" to increase; press "-" to decrease
◦ GREEN display shows the switching threshold value
◦ 2 seconds aer adjustment, the GREEN display will ash 3 mes to conrm
• Slide Mode switch to RUN to complete operaon
Remember: Manual adjustments are disabled when Auto Thresholds are ON
Follow these steps to perform a Light SET:
Note: TEACH Selecon must be programmed to Lt SEt.
1. Enter Adjust Mode
Method Acon Result
SET Buon
14
Set Mode switch to ADJ Display: Red - Signal Level; Green -
Threshold
Remote Input
15
No acon is required; sensor is ready for
Light SET method
2. SET Sensing Condion
14
SET Buon: 0.04 seconds ≤ "Click" ≤ 0.8 seconds
15
Remote Input: 0.04 seconds ≤ T ≤ 0.8 seconds
DF-G3 Long Range Expert
™
Dual Display Fiber Amplier
www.bannerengineering.com - Tel: 763.544.3164 21