Method Action Result
Push Button Press and hold TEACH for longer than 2 seconds.
and flash alternately
on the display. The DYN, FGS, and
BGS indicators flash.
Remote Input No action required. N/A
3. Teach the sensor.
Method Action Result
Push Button Press TEACH to teach the target. The sensor is taught the first target.
, , and the current
distance measurement flash
alternately on the display. The DYN,
FGS, and BGS indicators flash.
Remote Input Single-pulse the remote input.
4. Present the target.
Method Action Result
Push Button
Present the second target. The sensor-to-target distance must be
within the sensor's range.
, , and the distance
measurement flash alternately on the
display. The DYN, FGS, and BGS
indicators flash.
Remote Input
5. Teach the sensor.
Method Action Result
Push Button Press TEACH to teach the target.
The new switch point flashes rapidly
and the sensor returns to Run mode.
Remote Input Single-pulse the remote input.
Table 2: Expected TEACH Behavior for Two-Point Static Background Suppression
See Figure 20 on page 28 for the minimum object separation.
Condition TEACH Result Display
Two valid distances that are
greater than or equal to the
horizontal minimum object
separation
Sets a switch point between the two taught
distances.
The switch point distance flashes
on the display.
Two valid distances that are less
than the horizontal minimum
object separation
Sets a switch point in front of the furthest
taught distance by the horizontal minimum
object separation.
and the switch point
distance flash alternately on the
display.
One valid distance with one invalid
TEACH point
Sets a switch point between the one taught
distance and the maximum range.
and the switch point
distance flash alternately on the
display.
Two invalid TEACH points
Sets a switch point at the following location:
Model Switch Point
100 mm threaded barrel models 99
300 mm threaded barrel models 290
110 mm flush mount models 109
310 mm flush mount models 300
and the switch point
distance flash alternately on the
display.
Q4X Stainless Steel Laser Sensor
www.bannerengineering.com - Tel: 763.544.3164 17
To Next Page
Loading...
