The object is close to the reference surface
PROBLEM:
Move the target closer to the sensor
SOLUTION:
The sensor is far from the object
PROBLEM:
Move the sensor closer to the target
SOLUTION:
Figure 23. Common problems and solutions for detecting clear objects
5.4 Abbreviations
The following table describes the abbreviations used on the sensor display and in this manual.
Abbreviation Description
No valid signal in range
The sensor has not been taught
One-shot
First
Second
Two-point TEACH (static background suppression)
One-point background suppression
Button
Cancel
Display read
Output timing delay
Delay
Delay timer for one-shot
Dynamic background suppression
End—exit the sensor menu
Q4X Stainless Steel Laser Sensor
32 www.bannerengineering.com - Tel: 763.544.3164
To Next Page
Loading...
