(SELECT)(TEACH)
• Press to select menu items in Setup mode
•
Press and hold for longer than 2 seconds to start
the currently selected TEACH mode (the default is
two-point TEACH)
(+)(DISP)
•
Press to navigate the sensor menu in Setup mode
• Press to change setting values; press and hold to
increase numeric values
• Press and hold for longer than 2 seconds to switch
between light operate (LO) and dark operate (DO)
(-)(MODE)
•
Press to navigate the sensor menu in Setup mode
• Press to change setting values; press and hold to
decrease numeric values
• Press and hold for longer than 2 seconds to enter
Setup mode
NOTE: When navigating the menu, the
menu items loop.
1.4 Laser Description and Safety Information
CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure. Do not attempt to disassemble this sensor for repair. A defective unit
must be returned to the manufacturer.
Class 1 Lasers
Class 1 lasers are lasers that are safe under reasonably foreseeable conditions of operation, including the use of optical
instruments for intrabeam viewing.
Laser wavelength: 655 nm Output: < 0.20 mW Pulse Duration:
7 µs to 2 ms
Q4X Stainless Steel Laser Sensor
www.bannerengineering.com - Tel: 763.544.3164 5
To Next Page
Loading...
