Banner Q4XTBLAF300-Q8 - 3.6 TEACH Procedures; 3.6.1 Two-Point Static Background Suppression

Action Result
Four-pulse the remote input.
T T
T T T
T T
The sensor is ready to have the button
state defined and
displays.
2. Lock or unlock the sensor buttons.
Action Result
Single-pulse the remote input to unlock the sensor.
T
displays and the sensor returns to
Run mode.
Double-pulse the remote input to lock the sensor.
T T
T
displays and the sensor returns to
Run mode.
Triple-pulse the remote input to apply the operator
lock to the sensor
T T
T
T
T
displays and the sensor returns to
Run mode
3.6 TEACH Procedures
Use the following procedures to teach the sensor.
To cancel a TEACH procedure, press TEACH for longer than 2 seconds, or hold the remote input
Low for longer than 2
seconds.
momentarily displays when a TEACH procedure is canceled.
3.6.1 Two-Point Static Background Suppression
Two-point TEACH sets a single switch point. The sensor sets the switch point between two taught target distances, relative
to the shifted origin location.
2
Press and Hold
> 2s
Press again Press again
3
1
Switch
Point
Value
5
4
Figure 14. Two-Point Static Background Suppression (Light Operate shown)
NOTE: The sensor must be set to = to use the following instructions.
NOTE: To program the sensor using remote input, remote input must be enabled ( = ).
1. Present the target.
Method Action Result
Push Button
Present the first target. The sensor-to-target distance must be within
the sensor's range.
The target's measurement value
displays.
Remote Input
2. Start the TEACH mode.
Q4X Stainless Steel Laser Sensor
16 www.bannerengineering.com - Tel: 763.544.3164