Two-point static BGS
Dynamic BGS
One-point BGS
Dual, intensity + distance
One-point Window (FGS)
Top Menu
Set Response Speed to 1.5 ms
Set Response Speed to 3 ms
Set Response Speed to 10 ms
Set Response Speed to 50 ms
Set Response Speed to 25 ms
Off: no delays enabled
Enable on and/or off delay (set value in Delay Timer menu)
1 Shot, fixed output pulse duration
LO = On pulse when a target is detected inside of the switch point(s)
DO = On pulse when a target is detected outside of the switch point(s)
Near: set zero displayed value to end of 18 mm barrel
Far: set zero displayed value to maximum detection range
sec range, set Delay Timer value (seconds have decimal)
Gain menu is available when Response Speed is set to 10, 25 or 50 ms
†
Select Zero Reference menu is not available when in Dual Mode
‡
Shift Zero Reference menu is not available when in Dual Mode
Adaptive Tracking menu is available when Teach Process is set to Dual Mode
Laser off when pulled low
Laser on when pulled low
Set: Remote Teach input
Off: remote teach input is not active
Master
Slave
Display on
Display on, inverted
Display off (enters sleep mode after 60 seconds)
Display off, inverted (enters sleep mode after 60 seconds)
End: select to exit setup
No: do not reset to factory defaults
Yes: reset to factory defaults
On: move the zero point after each teach
Off: zero point is either at end of barrel or
maximum
detection range
to
Teach Process Selection
Response Speed
Output Timing Delays
Select Zero Reference Location
†
Delay Timer
Shift Zero Reference after Teach
‡
Input Wire Function
Display Read
Exit Setup
Reset to Factory Defaults
Available when
selected
Available when
selected
Sub Menus
ms
( default setting)
High excess gain mode
Standard excess gain with increased noise immunity
Gain and Sensitivity**
when is selected,1 to 9 ms is range available when Response Speed is
set to 1.5 or 3 ms
Adaptive Tracking ON
Adaptive Tracking OFF
High-Speed Adaptive Tracking ON
Adaptive Tracking Algorithm*
Figure 10. Sensor Menu Map—Channel 1
To Next Page
Loading...
