R5906790 /04 Athena122
Image 13-4
6. Check UHP power cable for dust and damage. See service manual for detailed procedure.
13.3 Installation of the Lamp House
WARNING: This procedure may only be performed by qualified technical service personnel.
Required tools
7mm nut driver or flat screw driver.
How to install the Lamp House in the projector?
1. Insert the Lamp House as follows:
1. Grip the Lamp House by the handle (4) and support it at the bottom with the other hand. Slide the Lamp
House in the lamp compartment.
2. Carefully insert the Lamp House into the projector. Make sure the positioning pins (reference 5, Image 13-
1) match the holes in the projector.
Image 13-5
Lamp House
To Next Page
Loading...
Need help?
General
