R5906790 /04 Athena 123
2. Tighten the three retaining screws (3) of the Lamp House. Use a 7mm nut driver or a flat screw driver.
Image 13-6
3. Close the fan door (2) and tighten the retaining screw (1) of the fan door.
Image 13-7
4. Install the rear cover of the projector. See “Installation of the rear cover”, page 149.
13.4 Resetting the lamp parameters
CAUTION: The LAMP INFO parameters must be updated any time a Lamp Module is replaced.
Neglecting to do this will result in poor performance and a reduced lamp lifetime.
How to reset the lamp parameters?
1. In the Communicator software, click on Installation (1) and click on Lamp (2).
Lamp House
To Next Page
Loading...
Need help?
General
