5. Advanced operation
When DPMS m ode is enabled on your display, an additional OSD power saving function
becomes available: hibernate. Please refer to "Hibernate", page 23 for more information
on hibernation and how to enable this function.
To enable/disable DPMS mode on your display:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the DPMS Mode submenu.
4. Select Enabled/Disabled as desired and confirm.
5.7 Hibernate
About hibernate
When hibernate is enabled, not only the backlight will be switched off, but also other functionalities will be
disabled to further reduce power consumption to a minimum. This happens after a specificperiodoftime
which can be manually adjusted.
Hibernate can only be enabled on your display when the DPMS mode is enabled first.
Therefore, please refer to "DPMS mode", page 22 to do this.
Please connect your keyboard or mouse to your PC rather than to the display USB ports
when hibernate is enabled.
To enable/disable hibernation on your display:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Hibernate submenu.
4. Select Enabled/Disabled as desired and confirm.
To specify the hibernate timeout:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Hibernate Timeout submenu.
4. Set the timeout value as desired and confirm.
5.8 Luminanc e target
About the luminance target
The luminance target of your Nio 3MP LED Display is adjustable over a predefined range. When you
change the luminance target, the display will adjust its backlight to reach the target.
K5902114 NIO 3MP LED DISPLAY 03/10/2016
23
To Next Page
Loading...
Need help?
General
