K5902149 /02 MDSC-833116
3.1 Cover removal
To remove the connector compartment cover
Slide the connector compartment cover downwards to get access to the connectors.
Image 3–1
3.2 Cable connection
About
The MDSC-8331 can have multiple video inputs connected. Switching between the different inputs can be
done easily with the Source shortkey (
).
Futhermore, if more than one video source is connected, the 2
nd
Picture functionality becomes available,
allowing you to view two different video inputs at once. Please refer to “2
nd
Picture Mode”, page 29 and for
more information.
Beside the video input connections, the MDSC-8331 also has video output capability allowing you to loop-
through the SDI signal on DVI out connector.
This chapter describes how to connect the different video interface types to the MDSC-8331.
To connect the cables
1. Connect one or more video source(s) to the corresponding video inputs of the display.
UHD 4K video can be connected in two ways:
• 1 x DisplayPort 1.2 connected to the DisplayPort input or,
• 1 x HDMI 4K connected to the HDMI 2.0 input.
Warning: DisplayPort VESA DP 1.2 certified cables for 5.4 Gbps HBR2 are recommended.
2. When the SDI video input is connected, SDI input is converted to TMDS signal available on DVI out.
3. Connect the RS–232C connector with a workstation to use the remote control protocol.
4. Connect the supplied external DC power supply unit to the +24 VDC power input of your display. Plug the
other end of the external DC power supply into a grounded power outlet by means of the proper power
cord delivered in the packaging.
Display installation
To Next Page
Loading...
