Barco MDSC-8331 - Contrast; Saturation; Sharpness; Setting Menu

K5902149 /02 MDSC-833128
5.3.2 Contrast
To adjust the contrast level
1. Bring up the OSD main menu.
2. Navigate to the Visual menu.
3. Enter the Contrast submenu.
The command bar Contrast is highlighted.
4. Set the contrast level as desired and confirm.
5.3.3 Saturation
To adjust the saturation level
1. Bring up the OSD main menu.
2. Navigate to the Visual menu.
3. Enter the Saturation submenu.
The command bar Saturation is highlighted.
4. Set the saturation level as desired and confirm.
5.3.4 Sharpness
To adjust the sharpness level
1. Bring up the OSD main menu.
2. Navigate to the Visual menu.
3. Enter the Sharpness submenu.
The command bar Sharpness is highlighted.
4. Set the sharpness level as desired and confirm.
5.4 Setting menu
5.4.1 Scale mode
About scale mode
The available scale modes for your display are:
• Fill All (displays full screen)
• One To One (1:1) (displays native resolution of the input signal)
• Vert-Fill (stretches the image vertically)
• Horz-Fill (stretches the image horizontally)
• Aspect (fill the screen on largest dimension, no modification in image aspect-ratio)
In both Aspect and Native, the image may be displayed with black bars on top/bottom or left/right.
To select the scale mode
1. Bring up the OSD main menu.
2. Navigate to the Setting menu.
3. Enter the Scale mode submenu.
4. Select one of the available scale modes and confirm.
Advanced operation