Connections
4-2 _________________________________________________________________________ R5976381.01 BARCO CINE6 31012002
Video input selection
a. with the RCU : press digit 1
OR
b. with the local keypad
- press ADJUST key, the GENERAL ACCESS menu is displayed on the screen
- use the control keys to highlight 1
- press ENTER to select the highlighted source
Connecting a S-Video to source 2.
Separate Y-luma/C-chroma signals for higher quality playback of S-VHS signals.
Input selection
a. with the RCU : press digit 2
OR
b. with the local keypad :
- press ADJUST key, the GENERAL ACCESS menu is displayed on the screen
- use the control keys to highlight 2
- press ENTER to select the highlighted source.
Connecting a RGB Analog source with composite sync.
RGB analog input terminals with composite sync input or with sync on green or separate sync. The projector detects automatically
where the sync signal is located. It accepts RGB at 15 and 32 K.
Always use an interface when a computer and local monitor have to be connected to the projector. Examples of interfaces which
can be applied :
Multifunctional Analog Interface Kit R9828121 (230V)
(MAGIK) R9828128 (120V)
TWIN interface R9828960 (120 - 230V)
VCR
Audio Amplifier
Luma / Chroma
S - VHS
GENERAL ACCESS
5 6
3 4
1 2
Enter ADJUST
Select with
or
then <ENTER>
<EXIT> to return
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
GENERAL ACCESS
5 6
3 4
1 2
Enter ADJUST
Select with
or
then <ENTER>
<EXIT> to return
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
To Next Page
Loading...
