Barco R9002372 - Connecting a Component Video Source; Connecting a RF Signal (Optional)

Connections
R5976381.01 BARCO CINE6 31012002 __________________________________________________________________________ 4-3
VCR
Audio Amplifier
TV Antenna
or Cable Network
RGBs (or RGsB) input selection
a. press digit 3 on the RCU
OR
b. with the local keypad :
- press ADJUST key, the GENERAL ACCESS menu is displayed on screen
- use the control keys to highlight 3
- press ENTER to select the highlighted source.
Connecting a Component source
YUV analog input terminals with sync input or with sync on the luminance (Y) input.
YsUV or YUVS selection
a. with the RCU : press digit 5 for YUV
OR
b. with the local keypad
- press ADJUST key, the GENERAL ACCESS menu is displayed on the screen
- use the control keys to highlight 5
- press ENTER to select the highlighted source
- for YUV at HDTV Standard select 6
Connecting a RF signal to the projector (optional) :
The projector automatically determines the presence of a tuner.
Connect the RF signal to the RF input of the projector.
Connect the audio output to an audio amplifier.
Audio Amplifier
GENERAL ACCESS
5 6
3 4
1 2
Enter ADJUST
Select with
or
then <ENTER>
<EXIT> to return
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
GENERAL ACCESS
5 6
3 4
1 2
Enter ADJUST
Select with
or
then <ENTER>
<EXIT> to return
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST