Barco R9002372 - Total Run Time; Change Password; Change Language; Change Projector Address

Service Mode
7-2 _________________________________________________________________________ R5976381.01 BARCO CINE6 31012002
Projector Set-up
Highlight PROJECTOR SET-UP with the arrow keys and then press ENTER, to display the projector Setup menu.
Within the projector setup menu, the following items can be setup :
- Identification
- Total run time
- Change password
- Change language
- Change projector address
- Change baud rate
- Powerup mode
- Common address
- Barco logo
Identification
Highlight IDENTIFICATION using the arrow keys and then press ENTER.
The Identification screen displays information concerning :
- Projector address. : To change the address of your projector,
contact a qualified service technician.
- Software version.
- Configuration.
Possible configurations :
Front ceiling
Front table
Rear ceiling
Rear table
- Baud rate PC. : Transfer speed for communication with an IBM PC or MAC. The Baud rate of the projector must be the
same as that of the connected computer. When there is a difference, contact a qualified service technician to make the
required changes.
- Text on/off. : Indicates in operational mode if the bar scale and value will be displayed and if warnings will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the TEXT key once on the RCU.
- Serial No. : Indicates the manufacturing serial number of the projector. This number can be useful when technical
assistance is required.
SERVICE MODE
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
or
<EXIT> to return
then <ENTER>
Select with
PROJECTOR SET-UP
PROJECTOR SET-UP
or
<EXIT> to return
then <ENTER>
Select with
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
POWERUP MODE : Standby
COMMON ADDRESS
BARCO LOGO
IDENTIFICATION
Cine 6
PROJ. ADDRESS : 0
SOFT. VERSION : 1.01
CONFIG. : front /
table
Baud Rate PC :9600
Text : on
Serial No. : 10359852