Service Mode
R5976381.01 BARCO CINE6 31012002 __________________________________________________________________________ 7-5
or
<EXIT> to return
then <ENTER>
Select with
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWERUP MODE : Standby
COMMON ADDRESS : 0
BARCO LOGO
Power up Mode
When switched on from the Power switch, the projector can start up in 'Operating
mode' or 'Stand-by mode'.
Operating mode : The projector starts up and displays the image.
Standby mode : The projector starts up in Standby and waits until the Standby
key or a digit key is pressed.
To change the powerup mode, select Power up using the arrow keys and then press
ENTER to toggle between Operating and Standby.
EXIT returns to SERVICE menu.
Common Address
Common Address is an address that all projectors respond to.
The toggling of this control sets the address to 0 or 1.
BARCO LOGO
By selecting this function, the BARCO LOGO can be enabled and positioned anywhere on the screen. Highlight 'BARCO LOGO'
using the arrow keys and then press ENTER. The BARCO LOGO menu is displayed.
The following functions can be selected :
- Mode : ON or OFF
- Size : Small or Large
- Background : ON or OFF
- Orbiting : ON or OFF
Select the desired function with the arrow keys and then press ENTER to
toggle the state of that function. EXIT returns to the PROJECTOR SETUP menu.
Memory Management
Highlight MEMORY MANAGEMENT using the arrow keys then press
ENTER to display the MEMORY MANAGEMENT menu.
Within the memory management menu, the following items can be
executed :
- copy a block
- delete a block
- delete all blocks
- all settings to mid position
- R & B convergence to mid
SERVICE MODE
COMMON SETTINGS
I2C DIAGNOSTICS
or
<EXIT> to return
then <ENTER>
Select with
PROJECTOR SETUP
MEMORY MANAGEMENT
MEMORY MANAGEMENT
or
<EXIT> to return
then <ENTER>
Select with
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MID POS
R & B CONVERGENCE TO MID
BARCO LOGO
or
<EXIT> to return
<ENTER> to toggle,
Select with
MODE : On
SIZE : Small
BACKGROUND : On
ORBITING : Off
you can move the logo on the screen,
using tge arrow keys.
Warning : Continuous use of BARCO
Logo damages the RED CRT
or
<EXIT> to return
then <ENTER>
Select with
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWERUP MODE : Stand by
COMMON ADDRESS : 0
BARCO LOGO
or
<EXIT> to return
then <ENTER>
Select with
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWERUP MODE : Stand by
COMMON ADDRESS : 0
BARCO LOGO
To Next Page
Loading...
