Controlling
R5976381.01 BARCO CINE6 31012002 __________________________________________________________________________ 4-1
CONTROLLING
Battery installation in the RCU.
2 new batteries are delivered inside the plastic bag with the power cord. Before using the RCU, install the batteries. Remove
the battery cover on the backside of the remote control by pulling the indicated lever a little to the bottom of the RCU. Lift up
the top side of the cover at the same time (fig. 1). Insert the new batteries (AA type or equivalent) in the compartment according
to the markings in the compartment, and put the cover back.
Batteries
Battery Compartment
Cover
The projector can be controlled with
a. The RCU
b. The hardwired RCU (cable not included)
c. The local keypad.
Controlling the projector with the RCU and the hardwired RCU is the same.
4
CAUTION : Do not display a stationary image with
full brightness and contrast for longer than 10
minutes, otherwise you risk damage to the tubes.
To Next Page
Loading...
