R5900049 /07 ClickShare CSE-800 71
Image 6-18: Display mode
3. Click on the drop down box and select the desired mode.
The following modes are available
• Extented
• Clone
4. Click on Save changes to apply the new settings.
Screen saver setup
1. Log in to the Configurator.
2. Click Display & Audio → Outputs.
3. To activate the screen saver, drag the slider bar to the left or to the right until the desired delay time is reached.
When the slider is set completely to the right, the screen saver will never be activated.
4. Click on Save changes to apply the new settings.
6.9 Audio settings
About the audio settings
The audio functionality can be disabled or enabled. When the enable and/or disable setting is changed, the
Buttons must be re-paired before the setting becomes active.
How to change
1. Log in to the Configurator.
2. Click Display & Audio → Display & Audio → Output.
CSE-800 Configurator
To Next Page
Loading...
Need help?
General
