R5900049 /07 ClickShare CSE-80086
Domain The company domain for which you are enrolling, should match with the one defined
in your Active Directory.
Identity Identity of the user account in the Active Directory which will be used by the
ClickShare Buttons to connect to the corporate network.
Password The corresponding password for the identity that you are using to authenticate on the
corporate network. Per Base Unit each Button will use the same identity and
password to connect to the corporate network.
Corporate SSID The SSID of your corporate wireless infrastructure to which the ClickShare Buttons
will connect.
Click Next to continue.
When having problems connecting the Button to your corporate network, to get feedback from the Button
please have a look at the ClickShare Client log. This log can be enabled by holding shift when starting the
Client executable. Look for the lines “EDSUSBDongleConnection::mpParseDongleMessages”. An error code
and a short summary of the issue should be logged.
6.16 Network integration, PEAP security mode
About PEAP
PEAP (Protected Extensible Authentication Protocol) is an EAP implementation co-developed by Cisco
Systems, Microsoft and RSA Security. It sets up a secure TLS tunnel using the servers CA certificate after
which actual user authentication takes place within the tunnel. This way of working enables it to use the
security of TLS while authenticating the user but without the need for a PKI.
The standard does not mandate which method is to be used to authenticate within the tunnel. But in this
application note, with regard to PEAP, we are referring to PEAPv0 with EAP-MSCHAPv2 as the inner
authentication method. This is one of the two certified PEAP implementations in the WPA and WPA2
standards – and by far the most common and widespread implementation of PEAP.
How to start up for PEAP
1. Log in to the Configurator.
2. Click WiFi & Network → Network integration. Click on Change configuraton.
3. Select the radio button next to PEAP and click Next.
Image 6-33: Network integration, PEAP selected
The PEAP mode window opens.
CSE-800 Configurator
To Next Page
Loading...
Need help?
General
