R5906113 /09 UDX32
3.2 Unpacking the projector
What has to be done ?
The projector is delivered in a cardboard box on a pallet and is secured with banding and fastening clips.
Furthermore, to provide protection during transportation, the projector is surrounded with polymeric foam.
Once the projector has arrived at the installation site, it needs to be removed from the box and pallet in a safe
manner, without damaging the projector.
After unpacking let the projector acclimatize to a room temperature between 10°C (50°F) and 40°C
(104°F). Neglecting this may result in a start up failure of the Light Processor Unit.
Required tools
cutter knife
How to unpack
1. Remove the banding around the cardboard box and open the box. Do this by releasing the fastening clips as
illustrated.
Image 3-2: Opening box
2. Remove the small box on top of the projector. This box contains the accessories such as manuals, remote
control, etc.
Image 3-3: Remove accessory box, polymeric foam and projector
3. Remove the polymeric foam from the top of the projector.
4. Open the plastic bag and lift the projector out of its packaging
Prepare to install
To Next Page
Loading...
Need help?
General
