R5906113 /09 UDX34
3.3 Initial inspection
General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As
soon as the projector is unpacked, inspect for any damage that may have occurred in transit. Save all packing
material until the inspection is completed. If damage is found, file claim with carrier immediately. The Barco
Sales and Service office should be notified as soon as possible.
Box content
After unpacking the projector it is recommended to check if all following items were included:
• One power cord of 2.7 m (3G10, 32A)
• One quick start guide
• One safety manual
• One web site reference sheet
• One remote control unit (RCU)
• Two batteries for the RCU.
Mechanical check
This check should confirm that there are no broken knobs or connectors, that the cabinet and panel surfaces
are free of dents and scratches, and that the operating panel is not scratched or cracked. The Barco Sales
and Service office should be notified as soon as possible if this is not the case.
Prepare to install
To Next Page
Loading...
Need help?
General
