EasyManua.ls Logo

Barracuda Networks NG Network Access Client SP4 - Configure Terminal; Show Dot1 X Interface

Barracuda Networks NG Network Access Client SP4
268 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
193 Barracuda NG Network Access Client - Administrator’s Guide
14.3.8 Re-authentication by the client service
The client service is able to enforce a re-authentication, given the configured interval (see 2.0.A),
independent of the switch's configuration. After the configured amount of seconds elapsed the Client
service will start the authentication sequence. By sending a EAPOL Start packet (see: 2.3.I) and
waiting for the identity request starting the authentication sequence (see: 2.3.II).
14.3.9 Periodic client re-authentication by the switch
You can enable periodic 802.1X client re-authentication and specify how often it occurs. If you do not
specify a time period before enabling re-authentication, the number of seconds between
re-authentication attempts is 3600 (1 hour). This option must be changed either through a command
line interface on the switch or the web interface.
Beginning in privileged EXEC mode, follow these steps to enable periodic re-authentication of the
client and to configure the number of seconds between re-authentication attempts.
Commands:
configure terminal
Enter global configuration mode
interface <interface-id>
Specify the port to be configured, and enter interface configuration mode
dot1x re-authentication
Enable periodic re-authentication of the client, which is disabled by default.
dot1x timeout reauth-period <seconds>
Set the number of seconds between re-authentication attempts.
The range is 1 to 65535; the default is 3600 seconds.
This command affects the behavior of the switch only if the periodic re-authentication is en-
abled.
end
Return to privileged EXEC mode.
show dot1x interface
Verify your entries
Table 14–10 Registry entry for 802.1X authentication
Item Description
Path
HKEY_USERS\.Default\Software\phion\phionvpn\settings
Key 8021XReAuthPeriod
Value Desired number of seconds the "Client" service must wait until re-authentication (Default 3600 seconds)
0 - 4294967295
Changes of this value will take effect with the next health evaluation by the Barracuda NG Access Monitor service.

Table of Contents

Other manuals for Barracuda Networks NG Network Access Client SP4

Related product manuals