A: R104GB04A.PMD
B:R104DE04A.PMD
E: 010404 / TCS
G: 140404 / T. Wenger
Section 4
Page 2
Inserting a token command
You can now select the corresponding axis.
After you have selected an axis, e.g. the Z-axis
as shown here, the key turns blue and the
commands which you can use are displayed.
R10B4_084.BMP
Once you have selected the required command
it also turns blue and a
blue arrow appears on one of the
softkeys.
Select the softkey with the blue arrow (continue)
to confirm your choice.
To Next Page
Loading...
