Operating manual for BAUER RAINSTAR series TX Plus 11
Move the gear-shift lever to the „PE-pipe pull-off“ position. A
spring presses the lever up and locks it.
5.2.3 PE-PIPE PULL-OFF
Pick up the draw-out hook with the toolbar and start pulling
the cart .
The standard wheel cart or the asymmetric wheel cart need
not be hoisted (therefore 1 draw-out hook is sufficient).
Pull-off speed: do not exceed 5 km/h!
Do not stop abruptly. Always slow down gradually at an intermediate stop in the field or at the end of the pull-off.
Stop pulling off the pipe when the white marking line becomes visible on the reel.
If the PE-pipe has been exposed to the sun for a longer period or if its surface
temperature rises above 35 °C for some other reason you must let water run
through the pipe to cool it off before the unwinding or retraction procedure.
WARNING!
To Next Page
Loading...
