Bauer Rainstar TX Plus Series - Mechanical Speed Control; Speed Control Mechanism; Speed Control Adjustment Table

Operating manual for BAUER RAINSTAR Series TX Plus 50
9 Mechanical CONTROL
The retraction speed is infinitely variable with the speed
regulating lever which is secured with the knurled nuts after
the setting. It remains next to constant from the first to the last
layer and on each individual layer. This is achieved by
readjustment of the turbine speed through the speed
compensation bar fitting closely on every PE-pipe layer during
the run ...
... and the regulating rods which actuate the regulating flap
located directly on the turbine.
Varying soil conditions and low flow rates may cause uneven
retraction speeds in spite of the layering mechanism. If
retraction speeds up or slows down, the regulating rod must
therefore be hooked up in the next suitable hole.
Proper speed control adjustment depends also on the PE-pipe diameter and differs for pipe dimensions 65 -
90 mm.
MECHANICAL SPEED CONTROL SETTING ON TX RAINSTARS
Wassermenge
Water flow
Débit
Einzugsgeschwindigkeit
Retraction speed
Vitesse d’enroulement
Loch/Hole/Trou
m³/h m/h
65 TX Plus 75 TX Plus 85 TX Plus 90 TX Plus
13 10
25
5
1
6
6
3
1
-
-
20
10
20
35
8
7
8
6
6
6
7
5
6
9
1
1
26
10
25
45
8
7
8
6
6
7
5
7
7
7
6
6
32
12
25
55
9
8
9
7
6
6
7
8
7
7
7
7
52
15
25
60
-
-
-
-
-
-
9
9
9
9
9
9