Operating manual for BAUER RAINSTAR series TX Plus 53
Procedure for data input:
1. Press the following 3 keys simultaneously for at least 3
seconds. The number 1 (constant no. 1) appears blinking on the display – enter the pulses per metre
according to sheet 1 or 2.
2. Press the to increase the value, and the to reduce the numerical
value.
3. Push the to proceed to the next following constant. The data input corresponds to
the step described above. Enter the data up to the constant "A" or keep the
depressed until
"b" appears.
4. When “b” appears on the display, push the to save the machine data. .
Thereby the machine data are saved permanently and they remain stored in the electronic system even if
the battery is replaced.
5. Checking the version number of the electronic system: Press the first and then the
- the version number appears on the display.
The speed indicated on the tachometer applies only to innermost PE-pipe layer
(depending on the respective transmission). For 2
nd
, 3
rd
and 4
th
layer you have to
take the retraction speed from the diagram. The radial lines on the diagram stickers
symbolise the individual PE-pipe layers.
10 EMERGENCY SHUT-OFF
If something unforeseen happens you can interrupt pipe
retraction. Pull or push the gear shift lever with your open
hand from gear position I or II into the middle position. (Do
not operate the lever with your hand closed, or let it go
immediately). The gearbox is disengaged, 0 position. A
spring presses the lever up (shut-off position) and prevents
fast reversing of PE-pipe or reel.
WARNING!
LAYER GEAR ON
ON key
GEAR key
LAYER key
ON key
LAYER key
ON key
LAYER key
To Next Page
Loading...
