Operating manual for BAUER RAINSTAR Series TX Plus 52
Operating steps:
1. Press the - to switch on the display.
Note! The display is switched off automatically after 4 minutes.
2. Press the until the current pipe layer is displayed.
3. Press the until the current gear is displayed.
4. Immediately the retraction speed in m/h is displayed on the right of the display.
5. While you hold the depressed, the display shows the revolutions per minute at the
gearbox input.
6. A blinking
Lo on the display indicates low battery voltage (lower than 7.5 Volt) – the battery must be
replaced!
Programming the machine data
The tachometer is supplied with standard factory setting according to the table below. In order to ensure that
your machine displays the precise and valid retraction speed, the specific parameters of your machine must be
programmed.
Constant no.
Description
Possible setting
range
Standard
setting
1 Pulses per meter in gear step 1 100-4000 1000
2 Pulses per meter in gear step 2 100-4000 900
3 Pulses per meter in gear step 3 100-4000 800
4 Pulses per meter in gear step 3 100-4000 700
5 Pulses per meter in gear step 3 100-4000 600
6 Pulses per meter in gear step 3 100-4000 500
7 Inner reel drum diameter (in mm) 500-3000 1400
8 PE-pipe diameter (in mm) 40-200 100
9 Number of pipe layers 1-9 5
A Number of gear stages 1-6 3
b Data are saved by pressing the "ON" key .
Please take specific machine data of the individual models from the table.
ON key
LAYER key
GEAR key
ON key
To Next Page
Loading...
