Bauer Rainstar TX Plus Series - Setting the Shifting Gate (8)

Operating manual for BAUER RAINSTAR Series TX Plus 60
19.3 SETTING THE SHIFTING GATE (8)
The shifting gate (8) must be set symmetrically to the gearbox shut-off range.
Procedure:
Switch into 1
st
gear (position “I”). Turn the V-belt pulley (9) - die
the PTO shaft (10) will rotate, too!“ Slowly shift the gear shift
lever (5) towards „0“. The shut-off point is reached when the
PTO shaft no longer turns along. Set the shifting gate in this
position according to the drawing (1 - 2 mm)!
Switch into 2
nd
gear (position “II“). Proceed as described above.
If the spacing is smaller than 1 mm or large than 3 mm, the
difference must be split up equally on both sides!
2
I
II
0
2
I
II
0
= =
I
II
0